Editing Scanco Administration (section)

====Error: High resolution 30 µm scans and avoiding buffer overrun error====
If you get an error of a Buffer Overrun when scanning at high resolution on the XtremeCT II, use this command prior to open the measurement software from the very same terminal:

<pre>
$ DEFINE UCT_MEASUREMENT_SHARED_FRAMES 1
$ uct_measurement
</pre>
This could be set permanently, but it may then also delay the patient scan saving.

[[Image:Redirect.jpg|15px]] [[#top|''Return to Contents'']] or [[Main_Page|''Return to Main Page'']]