Editing Scanco Administration (section)

===Disable a database measurement===

It is not possible to delete an evaluation from the database, but it can be disabled.

NOTE: QC results are stored in the UCT database, and there is no tool to disable a UCT database result.

Log in as the normal user (e.g. XTREMECT2). Then in a terminal you may use this simple utility program:
  $ RUN UT:UPAT_CORRECT_VALID_FLAG

See below a typical prompt to deactivate an entry:
<pre>
UPAT_CORRECT_VALID_FLAG V2.0

Measurement No. (0 to stop): 1
Evaluation type [2]: 5  ! E5 for trabecular bone; enter 6 for E6 for cortical bone (run the command twice)
Group code [0]: 0

Found evaluation 57 for patient 4: ID003

Value for valid flag (0=invalid, 1=valid) [1]: 0
Value for placeholder flag (0=write results, 1=placeholder) [0]: 0

Measurement No. (0 to stop): 0
</pre>

You can always re-activate the entry, by switching the valid flag from 0 to 1. 


Or, to make a scan invalid, you can also login as calibration user.

Point to microct user

 $ @DISK1:[MICROCT]LOGIN.COM

Set priviledges to bypass.

 $ SPB

Run Correction File
 $ run DISK1:[CALIBRATION.UTIL]UPAT_CORRECT_VALID_FLAG.EXE


[[Image:Redirect.jpg|15px]] [[#top|''Return to Contents'']] or [[Main_Page|''Return to Main Page'']]