Editing Scanco Administration (section)

====Incorrect first measurement number====
When sample information (such as patient name, DOB, remark) is changed DURING scanning, this can over write the 1st Scan measurement number, resulting in the evaluation sheet not being printed, and data not shown when running upat_list. For example, this happens when:

1) open sample program, enter name, hit save, leave program open

2) start scan (which would write correct record with 1st meas. in sample database)

3) in sample program: then only enter DOB, and hit 'save' again in the sample program --> it 'overwrites' the 1st meas. with an empty string again.

If you want to enter DOB after the scan has started, you HAVE to 'Find...' and re-load that patient first (so it correctly loads the 1st meas. entry also). It is best to just not use the sample management program whilst scanning is taking place. 

However, if you do encounter this problem, use the following to fix (shown using patient 668 as an example. 1st scan measurement number was 2672):
<pre>
 $ set host 0
 calibration
 xxxxx

 $ spb
 $ @[microct]microct_setup
 $ run [calibration.util]uct_correct_first
 $ r UCT_CORRECT_FIRST

 Patient Nr.: 668
 SampleNr.:          668
 First:            0

 2672

 Patient Nr.:
</pre>
and continue with next non-working patient, give patient number 0 to exit.

 $ logout


[[Image:Redirect.jpg|15px]] [[#top|''Return to Contents'']] or [[Main_Page|''Return to Main Page'']]