Editing Scanco Administration (section)

====Error: positioning====
This can have two reasons usually:

#The tape is just faulty. Try with a fresh tape.
#A previous tape write operation was interrupted (e.g., a user did an 'End Session', the power went out, or the eject button was pressed on the tape drive, which killed the backup program). In this case the drive did not write the very important 'End of Tape' marker, and now, the tape drive cannot find the current place where it can start adding new data. 
*Solution: either take a fresh tape, or if there were only a few scans are on the 'bad' tape, 'Move to Hard Disk' of ALL the scans on that tape, check that the scans have been retrieved well, then initialize that tape again (which will erase everything on the tape!) and archive those scans again. 
*IMPORTANT: never interrupt the tape drive while it is running!


[[Image:Redirect.jpg|15px]] [[#top|''Return to Contents'']] or [[Main_Page|''Return to Main Page'']]