Editing Scanco Administration (section)

=====Moving data disk directories=====

Sometimes when the data disk (DISK2) is getting too full measurement directories can be moved to a temporary location. We can move from DISK2 to another location:

 BACKUP DISK2:[XTREMECT2.DATA.00002784...] DISK7:[XTREMECT2.DRF_STORE.00002784...]/LOG/VERIFY

and back again:

 BACKUP DISK7:[XTREMECT2.DRF_STORE.00002784...] DISK2:[XTREMECT2.DATA.00002784...]/LOG/VERIFY

Check out the options for the <code>BACKUP</code> command for more options. One that might be useful is the <code>/DELETE</code> option, which deletes the files after verifying the move.

Sometimes the <code>uct_backup</code> tool loses information about where the data is stored after it's been moved back to DISK2. In this case you can reset the location as follows:

:*Start <code>uct_backup</code>
:*Navigate to the scan in question and you'll see the IMA section is blank
:*While holding the <code>SHIFT</code> key click on the radio button for IMA
:*In the blank text box, type "DK0" and the rest of the path should automatically fill out
:*Save the new path location information

Now you can run <code>UCT_EVALUATION</code> as you normally would. Do not use <code>DEF UCT_DEFAULT_ISQ DISK2:[XTREMECT2.DATA.00002784.00012345]D0013456.ISQ</code> because the evaluation will not complete properly because information about sample/measurement will not be available.

[[Image:Redirect.jpg|15px]] [[#top|''Return to Contents'']] or [[Main_Page|''Return to Main Page'']]