Editing Scanco Administration (section)

====Consistently needs warm-up scanner - Shutter-failsave-Job====

If the scanner is consistently needing to warm-up on consecutive days, and was not powered off, this is likely due to the Shutter-failsave-Job disappearing from the 3309-Batch queue (for XT1). The job must be re-submitted. 

The executing file is located in the CALIB3309 ($ um:submit_shutter_test.com) and the command to submit the job is:
<pre>
$ submit/after="tomorrow"/noprint/que=uct_measurement_queue um:submit_shutter_test.com
</pre>

You can check the status by typing: 
<pre>
$ show que *3309_batch*/all
</pre>

This job tends to disappear now and then, perhaps because of an abrupt shutdown of the workstation or maybe when stop/pause/re-start the queue. Contact Scanco if this does not resolve.


[[Image:Redirect.jpg|15px]] [[#top|''Return to Contents'']] or [[Main_Page|''Return to Main Page'']]