Editing Scanco User Instructions (section)

===Advanced Settings===
*'''Number of Det-lines (for Scout-View)''': Defines how many lines on the detector shall be used during the Scout-View. Using all available lines provides faster Scout-Views but some faint horizontal lines might be seen between the stacks. Limit the number of lines to a small number to obtain Scout-Views without these artifacts but the time of the Scout-View will increase.

*'''Number of Det-lines (for CT-scan)''': Defines how many lines on the detector should be used. This number influences the number of slices within a stack. Limit the number of detection lines if you see residual cone beam artifacts.

*'''FOV/Scan Diameter''': Chose the diameter of the FOV. This action is cropping the area of the detector.

*'''Software binning''': factor of the pixels on the detector.

*'''Hardware binning''':

*'''Samples''': number of (possibly binned) pixels on the detector that are used for each slice (note: this number is given for the whole FOV).
*'''Proj/180°''': number of projections taken per 180° turn of the sample.


[[Image:Redirect.jpg|15px]] [[#top|''Return to Contents'']] or [[Main_Page|''Return to Main Page'']]