Editing Scanco User Instructions (section)

===Reconstruction===

*After each image stack is acquired, it is automatically submitted to the queue (sys$slow) for reconstruction. The reconstruction for each image stack is split into four jobs to make efficient use of processors. 
*The reconstruction time depends on the resolution setting, with low resolution scans reconstructing faster than high resolution scans. Normally scans are reconstructed within a day or two. 
*It is possible to resubmit a scan for reconstruction (refer to [[Scanco_Administration#Reconstruction | '''Scanco Administration's Reconstruction''']]) for details. This may be necessary or desirable for several reasons:
#The sample did not reconstruct properly (e.g., due to a power failure)
#To reconstruct the object at an angle (e.g., so that the anterior surface of a bone is always in the same direction).
#A new beam hardening correction was applied to the sample
#The scaling was changed for the sample to change the brightness


[[Image:Redirect.jpg|15px]] [[#top|''Return to Contents'']] or [[Main_Page|''Return to Main Page'']]